Arcrite installs three robotic welding cells at Den Mar
Arcrite Automation completed three dual-station robotic welding cells for Den Mar Corp in Dartmouth, Massachusetts, giving the fabricator more output per shift without dedicating a robot to each product. The systems are designed to handle four steel part variations per cell using Den Mar’s existing fixtures.
Why it matters: - Den Mar Corp can now weld more steel parts per shift while using less manual labor. - The setup is designed to shorten lead times and keep weld quality consistent across multiple part variations. - The project shows how a manufacturer with mixed parts can automate production without buying a dedicated robot cell for every product.
What happened: - Arcrite Automation completed three dual-station robotic welding cells for Den Mar Corp, a Dartmouth, Massachusetts manufacturer of small and large steel components. - The cells are built to handle four steel part variations each. - The installation was completed for a Massachusetts fabricator operating from Den Mar’s existing production setup.
The details: - Each cell uses one ABB IRB 2600ID robot serving two welding stations. - While the robot welds at one station, an operator unloads finished parts and loads the next workpieces at the other station. - Each cell includes four BuildPro Max welding tables, with two tables per station. - Arcrite integrated the tables with Den Mar’s existing fixturing plates. - The system is designed to provide repeatable positioning across four part variations without separate equipment for each product. - Each system includes an ABB IRB 2600ID robot with an 8 kg payload and 2-meter reach. - Each system includes a Lincoln Power Wave R450 power source with a water-cooled robotic torch. - Each system includes an Abicor Binzel automatic torch cleaner. - Each system includes two operator consoles with start, stop, reset, and emergency-stop functions. - Safety light curtains stop automatic operation when an operator enters the protected area. - Arcrite built the cells around Den Mar’s existing fixturing and part geometries instead of requiring Den Mar to change production to fit a standard cell. - Arcrite also provided one week of on-site training at Den Mar’s facility. - The training covered basic robot functions, programming fundamentals, and full system operation. - Den Mar’s team was trained to manage daily production and switch between the part configurations supported by the cells.
Between the lines: - The project highlights a common automation challenge in fabrication: parts often vary too much for a single-purpose robot cell to be efficient. - Dual-station design helps reduce robot idle time because loading and unloading can happen while the robot is welding. - Arcrite’s approach centers on application-specific engineering, which can make automation easier for shops with mixed-part production.
What’s next: - Den Mar is expected to use the added welding capacity to increase throughput and finish orders faster. - The company can run the cells across four part variations per system without adding dedicated automation for each product. - Arcrite says it will continue supporting customers with troubleshooting, adjustments, and upgrades after installation.
The bottom line: - Den Mar gained flexible welding automation that boosts output without forcing a redesign of its production flow.
Disclaimer: This article was produced by AGP Wire with the assistance of artificial intelligence based on original source content and has been refined to improve clarity, structure, and readability. This content is provided on an “as is” basis. While care has been taken in its preparation, it may contain inaccuracies or omissions, and readers should consult the original source and independently verify key information where appropriate. This content is for informational purposes only and does not constitute legal, financial, investment, or other professional advice.
Sign up for:
Industry Reporter: Massachusetts
The daily local news briefing you can trust. Every day. Subscribe now.
Check Your Email!
We sent a one-time activation link to: .
Confirm it's you by clicking the email link.
If the email is not in your inbox, check spam or try again.
Welcome back!
is already signed up. Check your inbox for updates.